OneTouch Select Plus Flex User Manual

65
3
Taking a test
Removing the used lancet
NOTE: This lancing device has an ejection feature, so you
do not have to pull out the used lancet.
1. Remove the lancing device cap
Remove the cap by rotating
it and then pulling it straight
off the device.
2. Cover the exposed lancet tip
Before removing the lancet, place the lancet protective
cover on a hard surface then push the lancet tip into the
flat side of the disk.

OneTouch Select Plus Flex Specifications

General

Display	LCD
Bluetooth	Yes
Test Time	5 seconds
Measurement Range	20-600 mg/dL
Memory	500 tests
Sample Size	1.0 µL
Operating Conditions	10-90% relative humidity
Battery Type	CR2032