Customer Service 1 800 227-8862 41
3. Get ready to transfer readings
Connect the OneTouch
™
Interface Cable to the COM or USB port on
your computer.
Make sure the meter is turned off. If you insert the cable while the meter is
already on, the meter will not respond to computer commands. Then connect
the other end of the OneTouch
™
Interface Cable to the meter data port.
4. Transfer data
Follow the instructions provided with the OneTouch
™
DMS to download the
results from the meter.
Once the command to start the download is sent from the computer to
the meter, the meter display will show “PC” indicating that the meter is in
communication mode. You will not be able to perform a test when the
meter is in communication mode.
Reviewing past results and averages
Interface
cable
DCO_06344502A_OU2_OB_USe.qxd 3/13/07 11:52 AM Page 41
To Next Page
Loading...
