iv
• Getting to know your
OneTouch
®
UltraEasy
™
Blood Glucose Meter and
Test Strips
•
Turning your meter on and off
• Setting up your meter
NOTE: Before testing, read this
owner’s booklet carefully.
Table of contents
Setting up pg. 2
your system
Starting the test process pg. 7
Insert a test strip
Check the code on the test
strip vial before inserting the
strip. Make sure the three
contact bars are facing you.
Push the strip in as far as it
will go. Do not bend the strip.
The meter will turn on, show
a start-up test screen, and
then a code number. The first
time you use the meter, the
screen will display “––”
instead of a number.
Match the code displayed
on the meter with the code
on the test strip vial
If the code on the meter does
not match the code on the
vial, press ▲ or
▼
to change
the code. If the flashing blood
drop icon
R
appears on the
display before you are ready,
remove the strip and re-start
the test process.
The meter is ready for testing
when the flashing blood drop
icon
R
appears.
DCO_06397001C_OTUE_OB_GB.qxd 4/13/07 3:17 PM Page iv
To Next Page
Loading...
Need help?
General
