5
Setting the date:
After completing the time setup, the meter will automatically
move to date setup.
Year will flash…
• If the year displayed is correct,
press ‘OK’ to confirm.
• If the year displayed is not correct,
press
or to change the year
and press ‘OK’ to confirm.
Month will flash…
• If the month displayed is correct,
press ‘OK’ to confirm.
• If the month displayed is not correct,
press
or to change the month
and press ‘OK’ to confirm.
Day will flash…
• If the day displayed is correct,
press ‘OK’ to confirm.
• If the day displayed is not correct,
press
or to change the day
and press ‘OK’ to confirm.
After first time set up, you can adjust
the meter’s time and date settings by
pressing and holding ‘OK’ and
at the
same time. The SET screen will then
appear, and the hour will flash.
To Next Page
Loading...
