Onix ON-FLW8W - Page 4

After Sales Support
(AU) 1300 886 649 | tempo.org/support
4
General Safety Instructions (Cont.)
• CAUTION! Do not connect the appliance to the power supply using a power adaptor
or extension cord. Use of an extension cord does not guarantee the required safety.
• Winding the cord: If winding the power cord, avoid tight bends as this could damage
the cord.
• After use: Always unplug the appliance and turn off the water after use.
• Disconnect: Unplug the washing machine from the power supply before cleaning,
servicing, maintenance or moving the appliance. Pull by the plug, not by the cord.
• Keep openings clear: Do not insert any objects into ventilation or similar openings.
• No timer: The appliance is not intended to be operated by means of an external timer
or separate remote control system.
• RCD: Unless your home is already fitted with a residual current device (safety switch),
we recommend installing an RCD with a rated residual operating current not exceeding
30 mA to provide additional safety protection when using electrical appliances. See
your electrician for professional advice.
Installation
• WARNING! This appliance is extremely heavy. Transport with care! A team lift
or mechanical aid is required when moving the machine. Do not hold the washing
machine by the door or any other protruding part while lifting or transporting it.
• Freestanding use only: This appliance is not to be built in.
• Do NOT install the appliance:
– outdoors or in a damp or wet environment (such as a bathroom)
– in areas where caustic or explosive gases are present
– near open flames or heat sources
– behind a lockable door, a sliding door or a door with a hinge on the opposite side to
that of the washer in such a way that a full opening of the washer door is restricted.
• Installation surface: This washing machine must be installed on a flat, even and stable
ground to avoid overturning during use or maintenance. Do not place it on carpet. If the
machine must be positioned on carpet, place a plastic mat underneath the machine
and make sure any ventilation openings in the base are not obstructed.
• Clearances: Ensure that there is a distance of at least 200 mm between the appliance
and any external heat sources, such as appliances containing heating elements.
• Installation: Make sure that all water and electrical connections are made by
qualified persons only, observing local safety regulations and following the installation
instructions in this manual (refer to “Installation”, pages 10–16). Do not use the
appliance until it is fully installed.
• Water connection: This machine has only one inlet for water (cold). Do not connect it
to the hot water supply. Connect the machine to the water mains using new hose sets.
Do not reuse old hose sets. The required water pressure is 0.02 MPa (min.) to 0.8 MPa
(max.)