After Sales Support
1300 886 649 | tempo.org/support
3
General Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Read this manual thoroughly before first use, the safety precautions enclosed herein
reduce the risk of fire, electric shock and injury when correctly adhered to. Keep the
manual in a safe place for future reference, along with any warranty information and
your purchase receipt. If applicable, pass these instructions on to the next owner.
Always follow basic safety precautions and accident prevention measures when
using an electrical appliance, including the following:
Electrical safety and cord handling
• Voltage: Make sure your outlet voltage and circuit frequency correspond to the voltage
indicated on the appliance rating label and your outlet socket is properly earthed. If this is not
the case, do not use the dryer.
• Separate circuit: We strongly recommend you connect the appliance to a separate circuit serv-
ing only this appliance. This provides the best performance and prevents overloading the house
wiring circuits that could cause a fire hazard from overheating.
• Electrical hazard: Do not insert any objects into the appliance.
• No extension cord: Do not use this appliance with a power adaptor or extension cord. CAU-
TION: If such a device must be used, the cord or outlet device must be positioned so that it is
not subject to splashing or ingress of moisture.
• Protect the power cord. Do not kink or damage the power cord. Position the cord out of
the way so no one steps on or places anything on the cord or against it. Do not run the cord
under floor coverings. Arrange the cord away from traffic areas where it will not become a trip
hazard.
• Protect from moisture: Do not touch the plug with wet hands. Clean the plug only with a dry
cloth.
• Damage: Do not operate the appliance after it malfunctions or has been dropped or dam-
aged. In case of damage, contact our after sales support centre for advice.
• Damaged cord: If the power supply cord is damaged, do not attempt to change it yourself. A
damaged cord or plug must be replaced by the manufacturer or a qualied person in order to
avoid a hazard.
• Gas leakage: Do not connect/disconnect the power plug when there is a leakage of gas or
other combusible gases.
• Disconnect: Unplug the clothes dryer from the power supply after use, before cleaning,
servicing or moving the appliance. To disconnect, turn the appliance o, switch o the power
outlet and remove the plug from the power outlet. Grip the plug when disconnecting; do not
pull on the cord.
• RCD: Unless your home is already tted with a residual current device (safety switch), we
recommend installing an RCD with a rated residual operating current not exceeding 30mA to
provide additional safety protection when using electrical appliances. See your electrician for
professional advice.
• Winding the cord: If winding the power cord, avoid tight bends as this could damage the
cord.
To Next Page
Loading...