Onkyo DX-7333 User Manual

13
Useful Functions
PEAK SEARCH
A–B
REMOTE CONTROLLER RC-402C
PEAK SEARCH
+10 0
TIME EDIT
CLEAR
MEMORY
REPEAT
DISPLAY
78
45
12
9
6
3
NEXT
SELECTION
A–B SHUFFLE
This function searches for the peak sound level on the disc.
When using the memory mode, press the MEMORY button to
return to normal mode.
1. Press the PEAK SEARCH button.
•
The CD player checks the disc for the highest sound level. The
PEAK SEARCH indicator will flash during this operation.
When the search is complete, the indicator will light.
2. Press the A-B button.
“P” appears in the memory channel display area and flashes.
3. Press the button.
•
The section of the disc with the highest sound level will be
played repeatedly for 6 seconds. Refer to this level when record-
ing the disc onto a cassette tape.
4. Press the button.
The CD player stops.
•
This level is stored until the button is pressed or the power is
turned off. To repeat the 6-seconds playback of the peak level,
follow steps 2, 3, and 4 when the CD player is stopped.
•
Pressing the PEAK SEARCH button will turn off the PEAK
SEARCH indicator and the level will be cleared from the
memory.
•
Pressing the A-B button after pressing the button will start
the block repeat operation.
Note:
Depending on the disc playing, memorizing of a level which is not
the maximum audible level could occur. This is due to the CD
player’s microprocessor memorizing inaccurate information
because of flaws in the disc itself, or recording conditions. Under
such circumstances, the recording level for the cassette tape may be
very low, or else distortion or similar symptoms could arise on
account of excessively high signal levels. To avoid this, be sure to
reset the recording level of the cassette deck if such symptoms
occur.
Peak search (Remote controller only)
1
2
Remote controller
Remote controller
3
4
A–B
Remote controller
Remote controller
PEAK SEARCH
PEAK SEARCHPEAK SEARCH
LightsFlashes
DX-7333(E)BookPage132001年4月26日木曜日10:28AM

Onkyo DX-7333 Specifications

Audio Specifications

sampling frequency	352.8 kHz
frequency response	5 Hz - 20 kHz
total harmonic distortion	0.005% (at 1 kHz)
dynamic range	96 dB
signal-to-noise ratio	90 dB
channel separation	85 dB (at 1 kHz)
number of channels	2 (stereo)

Power

power consumption	9 watts
power supply	230-240 V, 50 Hz
output level	2 volts r.m.s.

Weight and Dimensions

weight	4.0 kg (8.8 lbs.)
dimensions	435 × 91 × 314 mm (17-1/8" × 3-9/16" × 12-3/8")