Using memory functions
1
3 4
2
i;;ii_2
DISC1 _SC2 OESCs o_¢_ _SCS _SC_
DISC 1 DiSC 2 DISC 3
DISC 4 DiSC 5 DISC 6
3
i;;ii_
MEMORy
Up to 40 tracks can be stored in memory.
1. Press the MEMORY button.
The MEMORY indicator will light tip.
2. Select the desired disc using the Direct Play buttons
(DISC 1-6).
• You may also use the DISC SKIP button to select a disc.
• if you wish to program the entire disc, select the desired
disc and press the MEMORY button. ("AL (all)" appears.)
• To use the number buttons on the remote controller to se-
lect the entire disc, press the "0" button.
3. Use the _/_l_l and _1 _ buttons to select the
desired track, and then press the MEMORY button.
The selected tracks are stored in memory.
You can use the number buttons on the remote controller to
select a track number. In this case, you do not need to press
the MEMORY button.
• To store tracks on other discs into the memory, repeat steps
2 and 3.
• Repeat Step 3 to select a track from the same disc.
• if you attempt to select more than 40 tracks, "FULL" will
flash on the time display to indicate that the memory is
full.
4. Press the ID_ PLAY button.
The CD changer will play the programmed tracks in the
order you selected.
• if you press the MEMORY button during playback, the
track being played will be stored in memory, You can use
the number buttons to program more tracks.
• You will need to select a disc each time you wish to pro-
gram a track from a non-current disc.
NOTES:
• if the total remaining time is more than 99 minutes 59 sec-
onds or when the contents of the memory extends to 2 or
more discs, "--:--" will be displayed.
• if a selected disc or track does not exist, the corresponding
indicator (disc or track) will light up and the selection will be
included in the program count, but the selection(s) will be
ignored and the subsequent disc or irack in the program will
play.
This Manual: http://www.manuallib.com/onkyo/dx-c380-compact-disc-changer-manual.html
To Next Page
Loading...
Need help?
Audio Specifications
