Onkyo HTX-22HD - Page 29

HTX-22HD
FIRMWARE UPDATE -1
Main microprocessor
PC (Personal computer)
RS232C
FFC
Flashwriter Jig
0JFLASH
HTX-22HD Rear Panel
Connector slot
for update
Flashwriter Jig
0JFLASHEX
4 line cuts
(for non-Main)
DSPHT205 : 08327A
Main1.00/08407A
* It depends on the version.
* It depends on the version.
(Target unit)
[How to Check Versions of Main and DSP]
1. Press [STANDBY/ON] button to turn on the unit.
2. Set MASTER VOLUME value to 10.
3. Hold down [INPUT] button and then press [STANDBY/ON] button.
Main FW version will be shown. (Main : Main microprocessor)
4. Press [LISTENING MODE] button.
DSP FW version will be shown. (DSP : DSP ROM)
5. Press [STANDBY/ON] button to put the unit into the Standby mode.
[Preparation for Update (Main)]
<NOTE>
Customer settings will be overwritten by the default settings.
Audyssey 2EQ setting will be necessary again after update because EQ settings set by Audyssey 2EQ cannot
be displayed to take a memo for manual setting.
<Tool>
1. Personal computer(PC) : 1 (Windows XP or 2000)
2. Flashwriter jig : 1 each
(1) 0JFLASH Part No. : 0JFLASH
(2) 0JFLASHEX Part No. : 0JFLASHEX (for non-Main with 4 line cuts)
3. Writing soft : "Update_DHT9HD_M_101.zip"(File name depends on the version.)
Unzip "Update_DHT9HD_M_101.zip" in advance.
* For a writing soft, contact Onkyo or your local distributor.
<Connection>
1. While a target unit is off, connect RS-232 terminal of 0JFLASH to PC and insert FFC(9 contacts) of 0JFLASHEX
to a connector slot on Rear Panel of the target unit.
2. Turn on the unit.