To Next PageTo Next Page
Need help?Do you have a question about the Online Electronics 3014X ATEX and is the answer not in the manual?
General| Model | 3014X ATEX |
|---|---|
| Category | Transmitter |
| Output | 4-20 mA |
| Type | Transmitter |
| Power Supply | 24 V DC |
| Operating Temperature | -20°C to +60°C |
| Protection Rating | IP |
Procedure for powering the transmitter on using the bleed screw and verifying function with an EM receiver.
Procedure for powering the transmitter off by loosening the bleed screw and verifying the status.
Steps to perform a function test using an EM receiver system to confirm signal reception and correct operation.
Pre-deployment checks including installation, visual inspection, and functional testing of the transmitter.
Instructions for selecting transmission rates (RATE 1 or RATE 2) by adjusting a switch inside the transmitter.
Procedure for replacing O-rings, including inspection, cleaning, and greasing of sealing surfaces.
Guidelines for cleaning the housing, checking components for damage, and proper storage procedures.
