January 16, 2020_V1
Requires 6 C batteries (not included).
Plug the AC power cord into a standard power
outlet.
Power and Batteries
Note: This unit is not compatible with MP3 CDs.
Loading and Playing a CD
1. Open the CD Door.
2. Place a CD into the unit, label side facing
up.
3. Close the CD Door.
4. Press the Power button to power the
speaker on.
5. Press the Source button to switch to CD
mode.
6. Press the
button to begin playing the
loaded CD.
7. Press the
buttons to skip tracks.
8. Press and hold the
buttons to
search through a track.
9. Press the
button to play tracks in
Repeat, Random, or Single Play Mode.
Note the figure in the display for Repeat
and Random Mode.
CD Player
Programming a CD
1. While a CD is playing, press , then press
and hold
to create a program.
2. “00” will begin flashing on the display.
3. Use the
buttons to select a track.
4. Press
to confirm the selection and add
it to the program. Repeat steps 3 and 4 to
add more tracks to the program. Up to 20
tracks can be added.
5. Press
to begin playing the program.
Press
to stop twice end the program.
Radio Reception
To improve radio reception, adjust the FM wire
antenna on the boombox.
Tuning the FM Radio
1. Press the Power button to turn the unit on.
2. Press the Source button to switch to Radio
mode, then:
3. Press and hold the
buttons to scan
radio frequencies.
4. Press the
buttons to fine tune the
radio frequency.
Saving Radio Presets
1. Tune to the desired FM frequency (see
above steps).
2. Press and hold the
button.
3. The display will show “Preset” and begin
flashing a preset number (Ex: “P01”).
4. Use the
buttons to select the
preset to be saved. Up to 10 stations can
be saved (P01 to P10).
5. Press the
button to save that preset.
6. With the radio ON, press the
buttons to cycle through radio presets
7. Note: To change a preset to a dierent
radio station start from step 1 and select
the preset station you want to change.
FM Radio
To Previous Page
Loading...