10
FM Radio
Adjust the position of the FM wire antenna to adjust radio reception.
1. Press the Power button to turn the unit on.
2. Press the Source button to switch to FM Radio Mode�
3. Press and hold the Skip/Tune buttons to scan FM frequencies. Press the Skip/Tune buttons to fine tune the
frequency adjustment.
Programming Radio Stations
1. With the speaker on and in FM Mode, press and hold the Program/Prog button on the unit or the remote. The
display will start blinking a preset number (Ex: P01).
2. Use the Skip/Tune buttons to select a preset number you wish to save, then press the Program/Prog button
again to save the frequency to that preset number. Up to 20 stations may be preset.
3. To select different presets, press the Program/Prog button, then use the Skip/Tune buttons to select a preset.
Programming a CD
1. While playing a CD, press the Stop button.
2. Press the Program/Prog button on the unit or the remote.
3. Press the Skip/Search buttons to select a track from the loaded CD to play first.
4. Press the Program/Prog button again.
5. Repeat steps 3 and 4 to program tracks from the loaded CD to play in the order they are selected.
6. Press the Play/Pause button to begin playing the programmed CD.
7. Press the Stop button twice to cancel the program.
CD & Radio
Loading & Playing a CD
Note: This unit is not compatible with MP3 CDs.
1. Press the Source button to switch to CD Mode radio mode.
2. Press the Open button to open the Disc Door.
3. Load a CD or CD-R/RW disc into the unit, label side facing toward you.
4. Close the Disc door.
5. Press the Play/Pause button to begin playing the loaded CD. Press the Skip buttons to cycle through different
tracks. Press and hold the Skip buttons to search through an audio track.
To Next Page
Loading...
Need help?
General
