Why are other AIS vessels unable to see my Onwa KS-200A Marine Radio KS200A?
If other AIS vessels are unable to see your Onwa KS200A, it could be due to several reasons. First, ensure that the KS200A is switched on. Check that the GPS and VHF antennas are properly connected. Also, verify the power supply voltage and replace it if it's incorrect.
What to do if my Onwa Marine Radio cannot switch on?
If your Onwa Marine Radio cannot be switched on, there could be a few reasons. The power cable might be broken, in which case you should replace or reconnect it. There might be a power supply problem, so you should check the power supply. Alternatively, the fuse may have blown, so replace it with a suitable rating fuse. If the fuse blows again after replacement, call for service.
How to fix the issue when I am unable to see AIS vessels around me on my Onwa KS-200A?
If you are unable to see AIS vessels around you on your Onwa Marine Radio, it might be because the KS200A/B is not switched on; in that case, switch it on. Another reason could be that the VHF antenna is not connected properly; try reconnecting it. Finally, there might simply be no AIS vessels in your vicinity; check again in a harbor.
Essential safety precautions for operators, including warnings about opening equipment and modification.
Critical safety guidelines for installers, emphasizing electrical hazards and proper fuse usage.
Describes Class B AIS standards and reporting intervals, noting KS-200A as a Class B unit.
Illustrates the system setup for the KS-200A transponder, including antenna and power connections.
Guidelines on cleaning and care for the KS200A/B, advising against user serviceability.
A troubleshooting guide addressing common problems like power issues and connectivity failures.
General| Channels (TX) | 55 |
|---|---|
| Output Power | 25W/1W |
| Modulation | FM |
| Power Supply | 13.8V DC |
| Waterproof Rating | IPX7 |
| Frequency Range | 156.025-163.275MHz |
| Voltage Range | 10.8-15.6V DC |
To Next Page