What to do if my Onyx International Scrubber machine cannot be operated?
If your Onyx International Scrubber machine won't operate, there are several potential causes: * The battery may have no power, in which case you should charge it. * The battery might be failing and needs replacement. * The battery wiring could be loose; ensure it is fastened securely. * The main fuse may have blown, requiring a fuse replacement.
Why is the waste water recovery rate low on my Onyx International Scrubber?
A low waste water recovery rate on your Onyx International Scrubber may be due to a full waste water tank, which requires draining. Alternatively, the water-absorbing adhesive tape (squeegee blade) might be worn and needs replacement.
What to do if the brush motor does not work on my Onyx International DX26 Scrubber?
If the brush motor on your Onyx International Scrubber isn't working, consider these possibilities: 1. The brush head may be raised; lower it to the ground. 2. The batteries may need charging. 3. The breaker of the brush motor circuit might have triggered a blackout; reset the button on the breaker.
What to do if the vacuum motor does not work on my Onyx International DX26?
If the vacuum motor on your Onyx International Scrubber isn't working, make sure the squeegee is lowered to the ground. Also, check the fuse of the vacuum motor and replace it if it's blown.
Why does the Onyx International DX26 Scrubber running time shorten?
If the running time of your Onyx International Scrubber is shortening, it could be due to flaws in the battery, requiring a replacement. Another cause might be the battery charging failing, in which case you should repair or replace the charger.
What to do if little or no water flows out of my Onyx International DX26 Scrubber?
If little to no water flows out of your Onyx International Scrubber, the filter or solution pipe of the clean water tank may be blocked, requiring you to clean the filter. Also, the speed of the flow control valve may be set too low (or shut); adjust the water control valve accordingly.
What if the water suction pipe is blocked in my Onyx International DX26 Scrubber?
If the water suction pipe is blocked in your Onyx International Scrubber, remove the blocked scraps. If the sealing strip of the waste water tank is damaged, replace the sealing stripe.
General| Brand | Onyx International |
|---|---|
| Model | DX26 |
| Category | Scrubber |
| Language | English |
To Next Page