Receiver unit
3.How to Pairing
Note: This package is already paired, if there is any disconnection or short range, please
follow below setting.
Hold the receiver’s pairing button for 3 seconds until the receiver has “Ding-Ding” sound.
Then press the kinetic bell push, then the receiver has “Ding” sound means pairing between
the kinetic bell push, and receiver is completed, The receiver will have another “Ding-Ding”
sound to exit pairing mode.
This marking indicates that this product should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased. They can take this
product for
environmental safe recycling.
To Next Page
Loading...