opendesk Studio Desk - Page 4

Mallet Fit
- 0.60mm total
The use of a mallet is
needed to push the part
into its respective slot.
Press Fit
0.00mm total
The joint is an exact
fit. This will require a
significant amount of
force, through hand
pressure or the use of a
mallet.
Type of fit
Push Fit
+ 0.20mm total
This joint should only
require hand pressure to
slot together.
Slide Fit
+ 0.50mm total
This joint should be easy
to assemble without being
too loose.
A face/edge
Surfaces such as tops and
top edges are always visible
and of high contact so
require an A type of finish.
Recommended procedure:
1. P120 grit
2. P240 grit
3. oil
4. P240 grit
5. oil
6. P320 grit
B face/edge
Surfaces which are
highly visible or easily
contactable.
Recommended procedure:
1. P120 grit
2. P240 grit
3. oil
4. P240 grit
Type of finishing
C face/edge
Surfaces that are not
directly visible or of low
contact. Generally areas
within joints.
Recommended procedure:
1. P120 grit
Deburring
Glued surface
This indicates the area for
glue application.
Oiled surface
This indicates the area for
an oil application.
No finish
This indicates the area
that have to be le raw.