Ops-Core Mesh Helmet Cover

To Next Page

SIZEFAST HELMET CUT

HIGH CUT

(FAST XP & LE)

SUPER HIGH CUT

(FAST MT)

M L XL XXL

06-16-000 REV. C

FOR FAST HIGH CUT & SUPER HIGH CUT HELMETS

MESH HELMET COVER

Fold the Mesh Cover’s Rear Velcro Tab over the edge of the

helmet shell and secure it to the newly placed Rear Velcro

Circle. Cut off any excess Velcro on Cover’s Tab.

Push the Rear Fitband Tab up and over the Cover’s

secured Velcro Tab as shown.

Pull the back of the Mesh Helmet Cover down. Align

both back side edges with the back side edges of the

FAST Side Rails (ARCs) as shown.

ATTACH BACK OF HELMET COVER

SECURE MESH HELMET COVER

Repeat Steps A-C for the opposite side, then

tighten both Rear Fitband Screws.

Loosen the Rear Chinstrap Anchor T-Nut and slide the Rear

Fitband Tab all the way back so that the corner of the helmet

shell is exposed. Clean area with Rubbing Alcohol, then adhere

a Velcro Circle to the exposed helmet shell corner as shown.

Velcro Circle

Location

Rear

Fitband Tab

Anchor T-Nut

Rear Fitband

Tab

Rear Velcro

Tab

Rear Velcro

Tab

INSTALLATION CONTINUED

Cover

Velcro Tabs

FAST Side

Rail (ARC)

Need help?

Do you have a question about the Ops-Core Mesh Helmet Cover and is the answer not in the manual?

Summary

INSTALLATION CONTINUED

ATTACH BACK OF HELMET COVER

Align back side edges of the Mesh Helmet Cover with the FAST Side Rails (ARCs).

SECURE MESH HELMET COVER

Secure the Mesh Cover's Rear Velcro Tab to the helmet shell and then attach the Rear Fitband.

INSTALLATION

MESH COVER INSTALLATION PREP

Detach the Fitband Comfort Pad from the Front EPP Pad by sliding it sideways.

SHROUD REMOVAL

Remove the Shroud from your helmet using a screwdriver and save parts.

ATTACH SIDES OF HELMET COVER

Align the Side Exterior Velcro of the Cover with the helmet's Side Exterior Velcro.

ATTACH FRONT VELCRO CIRCLES

Attach Velcro circles to the target areas on the Front EPP Pad.

RE-ATTACH SHROUD

Make small cuts on the cover for shroud screws and re-attach the shroud.

SECURE FRONT OF COVER AND RE-ATTACH FITBAND

Secure the cover using Velcro Circles and re-attach the Fitband to the Front EPP Pad.