Alarm silence (silence mode)
If the alarm has been activated by a non-emergency
situation you can place the alarm into Silence Mode.
To achieve this, push the test button once, this will pause
the alarm for approximately 10 minutes. The red LED will
continue to flash every 8 seconds to indicate that the alarm
is in Silence mode. The smoke alarm will reset itself after
approximately 10 minutes if the combustion particles have
been removed from the area. If they are still present after 10
minutes, the alarm will activate again, and the test button
should be pressed again to activate Silence Mode.
Note: By pressing the test button on the alarm that has been
activated, all interconnected alarms will silence. To reset
the LED’s, push the test button on each unit where the LED
is flashing.
Technical data:
Signal indication:
Wireless function description:
Wireless frequency: 433.42MHz
Operation current:
RF Receiver: < 6mA
RF emitter: < 30mA
Wireless distance: up to 100 meters – line of sight
1: Setting up Wireless Code
Note: Make sure the device is in normal standby mode.
Press the button 3 times in 2 seconds, the red LED aluminates
(No network yet) or the green LED aluminates (networking),
then the blue LED aluminates for 30 seconds, the detector has
entered "send wireless code mode".
Note: If successfully paired with another detector in "learning
mode", the green NET LED is lit for 3 seconds, then enter
"send wireless code mode" again. If there is no pairing for
continuous 30 seconds or press the button for 3 times within
2 seconds again, the detector will enter standby status.
2: Learning mode
Note: Before operation, the unit must be in normal working
mode.
Press the button for 3 times within 2 seconds, the unit first
enter " Learning mode " and the red NET LED (No
networking yet) or green NET LED (Already networking) is
lit for a while. Then, if the colour of the NET LED is same as
another detector in "send wireless code mode" (Green led
on 5s), it indicates the radio link is successfully paired. The
green LED will turn off after 3 seconds.
To Next Page
Loading...