9
Assembly & Instructions For Use
Instructions For Use
IMPORTANT! The appliance should be switched o and disconnected
from the power supply. Never operate without filters as this can cause
damage to the shampooer.
1. To remove the Clean Water Tank, hold
the handle and press the Clean Water
Tank Release Button.
2. Unscrew the measuring cap from the
reverse side of the Clean Water Tank.
Fill measuring cap with solution (one
full cap of solution per full tank of
water) and pour into the tank.
3. Fill the remainder of the Clean Water
Tank with warm (max 40ºC) tap water.
Screw back the measuring cap.
4. Insert the Clean Water Tank into the
body of the shampooer ensuring it
clicks into place.
To Next Page
Loading...
