8
Hold
Manual Hold: Grabs the current weight and holds it so it will not change/uctuate.
● While weighing, press the Hold key and the scale will hold the current weight on
the screen until HOLD is pressed again
Accumulation
● The accumulation function is used to add multiple weights and total them together
● In weighing mode load the rst weight, once stable press the ACC button on the
remote to enter the accumulation mode and accumulate the rst weight
● The display should show [ACC] if it shows [noACC] then the weight exceeded the
upper limit
● Remove your rst load and add your second load to the scale; press ACC
● Repeat previous step until all loads you want to accumulate have been added to the
scale
● Note: Incase of a mistake. Press DEL to clear the last accumulation data;
the display should show [deL]; if not it will display [nodeL]
● Press F1 to total your weights, the display should show [n###] (the number of
weights you are adding together) then it will display the total accumulated weight
for 3 seconds and return to weighing mode
● To clear the data, press the 2nd key and the display should show [2nd], then
press DEL to clear all the accumulation data, and the display should show
[CLEAr]
Weight Display
● Press F4, the display should show [StorE], and save the current weight value
● Press F3, the display should show [LASt0], use the arrow keys to choose a serial
number (most recent weights save as 0, the rst weight saves as 9)
● Press HOLD to display the corresponding weight for 2 seconds, then it will go
back to the weighing mode
To Next Page
Loading...
