10
OP-924
GRAVITATIONAL ACCELERATION
FACTOR CORRECTION
1. During calibration, when the display shows [CALon], press TARE to enter into
gravitational acceleration factor correction
2. It defaults to 1.0000 and controls the relationship to the weight in direct proportion
3. Use the arrow keys to modify the parameters then press HOLD to conrm
4. The display should now show [EnD ], press HOLD to conrm
5. Note: after weight calibration, the gravitational acceleration factor reverts to the
default value of 1.0000. If the work site is lack of weights, press modify the gravita-
tional acceleration factor to adjust the weight.
To Next Page
Loading...
