OPTIMUM
MASCHINEN - GERMANY
Assembly and maintenance instruction recirculating ball screw
5. Dezember 2007 Page 27Recirculating ball screw assembly and maintenance instruction ; Version 2.0
© 2007
GB
£ Check if the table is even and free
from soiling before assembling the
X-axis.
£ If there are any soilings, remove
them.
£ After machining clean and oil the
guideways.
CAUTION!
Imperatively remove any soilings,
otherwise it may be impossible to
travel the X-axis!
Fig.1-53: Checking the X-axis
Example soiling
Table X-axis
Guideways
To Next Page
Loading...