Cleaning Procedure
To clean the burrs chamber (every 6-12 months):
1. Power off the grinder.
2. Remove the lid.
3. Adjust the funnel towards the coarser direction until the
funnel disengages.
4. Remove the funnel and you will get access to the upper
burr carrier.
* Important: Watch out for the bearing (on upper burr carrier) and springs
in the grooves supporting the carrier - do not lose them.
5. Remove the upper burr carrier with hand gently.
6. You should now be able to access the burrs chamber
and clean the grinder with a brush or vacuum.
Note:
- When reinstalling the upper burr carrier, we STRONGLY
recommend to be extra careful to make sure that the burr is
going in perpendicularly (90 degree). Do not force the burr if it
feels stuck.
- There is no need to disassemble the burrs from their carriers
(both the bottom and upper burrs) for cleaning purpose.
To Next Page
Loading...
