2323
If you experience a problem with your
projector, please refer to the following
information. If a problem persists, please
contactyourlocalretailerorservice
center.
Image Problems
No image appears on-screen
•Ensurethecables/charger/
battery are correctly and securely
connected.
•Ensurethepinsofconnectorsare
not crooked or broken.
•Makesuretheprojectoris
switched on.
Image is out of focus
•AdjusttheFocusDial.
•Makesuretheprojectionscreen
is between the required distance
9.6 to 126.6 inches (0.245 to 3.215
meters)fromtheprojector.See
page 5.
Image is too small or too large
•Movetheprojectorclosertoor
further from the screen.
Imageisreversed
•Select“Setup-->Display-->
Projection” from the OSD and set
the projection direction.
Audio Problems
No sound
•Duringvideoormusicplayback,
press the button.
Battery Problems
Battery capacity is low
•Removethebatteryandcleanthe
connectors.
•Thebatteryiswornoutandneeds
to be replaced.
•Thebatterymaynotcharge
correctly after the projector
is turned off due to the high
temperature emitted by the
projector. Let the projector cool
for a while before connecting the
charger.
LED Indicator
LED Color
Description
No light In operation
Red Battery charging
Green Battery charging
Timing Table
Mode Resolution V-Sync(Hz)
VGA
640x480 60
800x600 60
1024x768 60
1280x720 60
1280x800 60
1024x600 60
Composite*
Component
HDMI
480i / 480P 60
576i / 576P 50
720p 50 / 60
1080i 50 / 60
<Note>
Video format does not support content with
B-Frame function.
<Note>
• TheLEDashesredwhenthe
projector temperature reaches 80°C.
It is recommended to switch off the
projector to allow it to cool down.
• When the projector temperature
reaches 85°C, the projector
automatically shuts down due to the
built-in temperature protection. This is
not a malfunction. Let the projector cool
down before switching it on again.
WhenacomputerisconnectedviaUSB,theprojectorautomaticallydetectsthe
connection and the message below appears on screen.
Video Music Photo
Input Office Viewer Setup
Press matched symbol to enter specific function directly
Yes
No
<Note>
Displayedscreenvaries
depending on the last session.
Returnstothepreviousscreen
1.
Confirm Transfer
<Note>
The screen turns black after 60 seconds for
powersaving.Press
to wake up the display.
or
2.
Upload Files by Computer
3.
Unplug the USB Cable
<Note>
Check your computer for the upload status.
When upload is complete, you must unplug the
USB cable to display the Home menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
