What to do if no lights turn on on Optoma Projector?
If no lights turn on on your Optoma Projector, ensure the power cord is securely connected to both the projector and a working power outlet. Try pressing the power button again. If it still doesn't turn on, unplug the power cord, wait a short while, then plug it back in and press the power button again.
How to fix a blurry image on Optoma Projector?
To fix a blurry image on your Optoma Projector, while the on-screen menu is displayed, adjust the focus ring. Ensure that the image size remains constant during adjustment; if the size changes, you're adjusting the zoom instead of the focus. Also, inspect the projection lens to see if it requires cleaning.
What to do if Optoma W319UST is searching source?
If your Optoma Projector is displaying 'searching source', press the SOURCE button on either the projector or the remote control to select an active input source. Ensure that the external source is powered on and properly connected. If you're using a computer connection, verify that your notebook's external video port is enabled, referring to your computer's manual if needed.
How to stabilize a flickering image on Optoma Projector?
To stabilize a flickering or unstable image on your Optoma Projector when connected to a computer, press the 'Menu' button, navigate to IMAGE > Advanced > Signal, and then adjust the Phase or Frequency settings.
Why is my Optoma W319UST Projector remote control not working?
If the remote control for your Optoma Projector isn't working, make sure nothing is blocking the remote control receiver on the front of the projector and that you are using the remote control within its effective range. Try aiming the remote control at the screen or directly at the front of the projector. Also, position the remote control more directly in front of the projector, avoiding extreme angles to the side.
To Next Page
General
