26 of 49
OP940-SW
Front Panel Operation
Settings Mode
The Settings Mode is designed to allow the user to configure certain parameters for the
unit including pass/fail criteria and startup mode.
The buttons will operate identically to Mode Select screen in the root Settings screen in
that buttons 1 , 2 , and 3 will select various settings for the unit such as measurement
pass thresholds and the temperature units displayed on the screen. Buttons 4 and 5
will navigate backward and forward, respectively, through the pages of settings. Pressing
the H button on the Settings screen will put the unit back into the Mode Select screen.
When wavelength-specific settings are selected, the operator will be taken to a
screen which allows them to select the particular setting to be set. The buttons
in these screens will function exactly as in the root Settings screen. Pressing the
H button in a settings screen will bring the unit back to the Settings screen.
Meanwhile, pressing H while in a screen devoted to a wavelength-specific
setting will bring the unit back to the higher-level screen, but not to the root
Settings screen.
For example, pressing H after changing the 1310nm RL pass criteria will take the
unit back to the screen for all of the RL pass threshold settings and then pressing
H again will bring the unit back to the root Settings screen.
The screens for non-wavelength-specific settings will treat the buttons as in the
operation modes (such as IL and RL modes). Buttons 1 , 2 , 3 , and 4 will select
options such as increasing/decreasing digits and selecting different digits. Button
5 will cycle through the pages of these procedures and options before wrapping back to
the first page. Pressing the H button in a specific setting screen will bring the unit back
to the root Settings screen.
For example, pressing H after changing the IL Precision setting will take the unit back to
the root Settings screen.
Settings Mode
To Next Page
Loading...