3
III.
II.
I.
-When the multibaycharger is not in operation, store it in
a dry and dust-free place with the six plugs in the round
sockets provided. This will prevent the connector from
becoming dirty.
-Before putting the multibaycharger into operation, place
it on a stable and clean surface or mount it on a wall.
Place your batteries in the rectangular battery slots.
Make sure that no cables are pinched by the batteries
and that all batteries are firmly in their slots.
-Remove the protective cover from the battery.
-Insert the plug in the cable connection of the battery.
(Repeat this step for each battery)
- Make sure the OFF / ON switch, located at the front of
the multi bay charger II, is OFF.
-Plug the power cord underneath the OFF / ON switch
as far as it will go.
-Press the OFF / ON switch to ON.
ON/OFF
To Next Page
Loading...
