optris PIX Connect – E2021-05-A
7
1. Getting started
1.1. Software installation
Please install at first the software PIX Connect which is included on the USB stick. The stick contains the
software application, the specific calibration data of the imager as well as some sample files. These data will
be installed automatically.
Note
Alternatively, the software can also be downloaded via the Optris website under the following link:
https://www.optris.global/pix
Please start the setup.exe from the USB stick. Follow the instructions of the wizard until the installation is
finished.
At the end of the installation, you will get an overview
of what has been added, changed and corrected in the
current software version. You will find this overview
again on the data medium under the document name
Changelog.
To Next Page
Loading...