Auto-lift adjustment
- The auto-lift mechanism has been adjusted at the factory to engage 10mm before the dead
groove. Since the distance between this groove and the spindle hole conforms to an
international standard, no further adjustment should be necessary. In the event that the
auto-lift triggers prematurely or not at all on some of your discs, the trigger mechanism
can be adjusted by turning the small screw located at the back of the tone arm tube at the
counterweight, with the small allen key provided.
- Clockwise rotation looking at the front of the turntable will cause the auto-lift to engage
earlier, counter-clockwise will cause it to engage later.
Cueing height adjustment
- the crew that adjusts the tone arm cueing height is located at the top of the arm base,
between the arm pillar and the VTA tower. Should adjustment be necessary, insert the
small allen key provided with its long side the horizontal plane to avoid interference with
the arm and turn the screw clockwise to lower the cueing height and counter-clockwise to
raise it.
PRELUDE TONE ARM
Owner’s manual
To Previous Page
Loading...
Need help?
General
