Battery Warning
Caution:
There is danger of explosion if batteries are mishandled or incorrectly replaced. On systems with replaceable
batteries, replace only with the same manufacturer and type or equivalent type recommended by the
manufacturer per the instructions provided in the product service manual. Do not disassemble batteries or
attempt to recharge them outside the system. Do not dispose of batteries in fire. Dispose of batteries properly
in accordance with the manufacturer’s instructions and local regulations. Note that on Oracle CPU boards,
there is a lithium battery molded into the real-time clock. These batteries are not customer replaceable parts.
Caution:
For product installed in California, USA: This product may contain a time-of-day battery which may contain
perchlorate where special handling may apply. See http://www.dtsc.ca.gov/hazardouswaste/perchlorate.
Energy Storage Module Caution
Caution:
There is a danger of shock or equipment damage if energy storage modules are mishandled or incorrectly
replaced. When replacing the energy storage modules, use only replacement modules that have been
provided by Oracle, following the instructions provided in the product service manual. Do not disassemble
modules or attempt to recharge them outside of the system. Do not dispose of the modules; instead, return
them to Oracle in accordance with Oracle procedures for the product.
System Unit Cover
You must remove the cover of your Oracle computer system unit to add cards, memory, or internal storage devices. Be sure
to replace the cover before powering on your computer system.
Caution:
Do not operate Oracle products without the cover in place. Failure to take this precaution may result in
personal injury and system damage.
Rack System Instructions
The following or similar rack-mount instructions are included with the installation instructions:
Elevated Operating Ambient – If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given
to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified
by the manufacturer.
Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of air flow required
for safe operation of the equipment is not compromised.
Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and
the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when addressing this concern.
Reliable Earthing – Reliable earthing of rack-mounted equipment should be maintained. Particular attention
should be given to supply connections other than direct connections to the branch circuit (for example, use of
power strips).
Caution:
Slide/rail mounted equipment must not be used as a shelf or workspace.
Rack System Warnings
To Next Page
Loading...
Need help?
General