Orava HM-03 - Page 9

9
EN
Unpacking/Packaging
• Unpack the equipment and accessories before putting it into service
and remove all parts of the packaging material and labels. Store the
packaging in a safe place, especially out of the reach of children and
unaccompanied persons, or dispose of them safely.
There is a risk of serious injury!
Risk of suffocation!
Check/Startup
• he appliance is designed for food preparation. Therefore, thoroughly
clean all parts before commissioning, following the instructions in the
Startup section. Cleaning and maintenance.
• Never clean the machine (its drive unit with electrical parts and
controls) and the power cord with the plug in a way (under running
water) that may cause the liquid to fl ow into the device.
• Clean these parts with a damp cloth only and wipe dry or let it dry.
• Only clean the appliance when it is switched off and disconnected from
the mains.
• It is recommended that you carry out the initial and subsequent periodic
inspections of the equipment.
• Never use the appliance if it is incomplete, damaged, or damaged
during transportation or use.
• Do not use non-original and incomplete parts of the device and its
accessories.
There is a risk of serious injury!
There is a risk of electric shock!
Location/Installation
• Only place the appliance on fl at, and stable pads - kitchen work desks
and furniture parts, suitable for the location of kitchen utensils.
• Always make sure that the place you want to place the device has
enough space, mechanical strength and appropriate lighting.
Warning!
• Do not expose the device to:
- direct sunlight, sources and equipment producing heat,
- vibrations and mechanical stress,
- excessive dust,
- water and excess moisture,
- insect,
- an aggressive external environment
• Do not use or dispose of the appliance:
- to unstable tables or parts of furniture,
- on an uneven and dirty surface,
- on the sealing edge of tables or parts of furniture,
- in the vicinity of containers with water or other liquids.
• Do not cover the device in part. Do not add anything to the device. Do
not insert or allow the foreign bodies to enter the holes of the device
covers.