EX 6000
14
2. Place S.S. filter in filter holder (without coffee powder in filter).
3. Place a jar or cup on removable tray. Ensure that steam knob is in OFF position.
Note: Appliance doesn’t include jar or cup, use your own one.
4. Plug appliance to mains, press button POWER the indicator light will flash. Wait until indicator light
doesn’t flash.
5. When POWER indicator light doesn’t flash, it means preheating is complete. Press MANUAL button
to water starts circulating.
6. Filling the jar 2-3 times, cleaning process is finished and you can brew coffee.
FILLING OF WATER TANK
1. Open water tank lid and remove tank pulling up.
2. Fill in tank with fresh water taking care not to exceed the MAX level. Replace water tank, pressing lightly
to open the valve located on the bottom of the tank.
3. More simply, water tank can filled without removing it, just opening lid and pouring water directly from a
jug.
IMPORTANT: It is normal, occasionally, there is a bit of water in the space below tank. Simply dry it
with a cloth or sponge regularly.
BASIC USE OF THE COFFEE MAKER
PREHEATING COFFEE MAKER
1. Open tank lid and fill it with enough quantity of water. Water quantity should not exceed maximum
level and not lower than MIN level.
Warning: in case of no water in the tank, the use of the machine will affect service life of the pump.
Please add water in time when the water level is below MIN level.
2. Plug coffee maker to mains and press POWER button. While it flashes, coffee maker is preheating. In
this moment buttons DOUBLE SINGLE y MANUAL don’t work if you press them. When light is
on, coffee maker is ready to brew coffee. To stop preheating, press again POWER button.
3. Place the filter you need in filter-holder, put it in coffee maker from “Insert” position and turn right to
“Locked” position.
4. Place coffee cup below filter-holder and when coffee maker is ready press MANUAL button for 5-10
seconds to purge coffee maker. Discard water of cup.
To Next Page
Loading...
