Orbegozo HOT 710 - Page 14

HOT 710
14
ATTENTION: do not cover the appliance when it is
operating to avoid the risk of fires.
ATTENTION: This symbol show: Hot surface. The
temperature of the door or the outer surface may be high
when the appliance is operating.
INSTALLATION
This oven has not been designed to be built-in. Place the unit on a dry and smooth surface and make sure
that the oven is a minimum 50 cm away from the wall and 20 cm both sides. The back should be placed
against the wall. Do not place it close to a closet.
Make sure the door can be completely open without resistance.
OPERATION AND USE OF THE OVEN
Orbegozo midi-oven is designed to be more economical and secure so as to ensure a longer useful life and
it is also equipped with a thermostat, a timer and two-way switches.
- Insert the oven’s plug into a socket. A yellow warning light shall come on to warn you that your oven
is supplied with electricity and is ready to be operated.
- By means of the timer button, you are enabled to ensure that your oven is operated during a pre-
determined period of time in compliance with table 1 and is then automatically turned off.
- By means of the thermostat button, you could set your oven’s temperature. This button serves to
ensure that your oven automatically starts and then turns off at desired temperatures. A red warning
light shall warn you when the thermostat and timer are on. The light shall go out when the timer or
thermostat is off.
- The third switch will allow you to activate the upper and lower heating elements, both heating
elements in turn, the grill will start and the rotisserie will turn.
- The switch will allow you to turn on the light and / or connect the convection.