Extracts from Orbit-Reader-20-User-Guide-V1.8 7
Serial - When using a screen reader that only supports Serial protocol, follow these steps:
1. Turn on Orbit Reader 20. It displays the last read material.
2. Connect the USB cable. "-- Charger connected" is displayed.
3. On Orbit Reader 20, press Space + Dots 3 7. "-- Remote Serial mode" is displayed.
4. Install any necessary drivers.
5. Configure the screen reader.
Mass Storage - To use an SD card inserted in the Orbit Reader 20 as a drive on your computer, follow
these steps:
1. Turn on Orbit Reader 20. It responds with braille from your last activity.
2. Connect Orbit Reader 20 with your computer using USB cable. "—Charger connected" is
displayed.
3. On the Orbit Reader 20, press Space + Dots 5 7. "-- Mass Storage mode" is displayed.
4. Use your PC to read and write files on the new drive.
13. Key Lock Command
The Key Lock command prevents accidental key presses. The command is to hold Dots 7 8 for two
seconds or more. Pressing and holding these same keys again, unlocks the keys. You can also unlock
the keys by turning the device off and then on again.
14. Reboot the Device
If the Orbit Reader 20 suddenly does not respond to button presses, and you know that the battery
is not fully discharged, then you may try rebooting the device by pressing the lower Right Panning
key + Dot 8. There is no indication of the reset event. The unit is in power off condition after reset
and needs to be powered on before it can be used.
Refer to the Orbit-Reader-20-User-Guide-V1.8 for all details and features of the device.
To Previous Page
Loading...