STEP 1
1. Carry$out$ the$machine$from$the$package$by$two$persons$ and$place$ it$lightly$on$flat$floor,$ and$ put$ other$
fittings$beside$the$mac h in e.$ $
2. Insert$the$left$upright$tube$into$base$frame,$fasten$it$with$1pc$M8*45$screw$and$1pc$M8$flat$washer,$1pc$
M10*50$ scr ew,$ 1pc$ M10$ flat$ washer$ and$ 1pc$ M10$ nut,$ 1pc$ M8*16$ screw$ and$ 1pc$ M8$ curve$ washer,$ then$
tighten$a ll$the $sc rews .$
3. Please$repeat$the$same$step s$on$the$right$side.$
$
$
$
$
$
!
!
!
!
!
STEP 2
Connect$the$signal$wire$at$right$upright$tube,$then$insert$the$console$into$both$upright$tubes$(pay$attention $
not$to$break$signal$wire),$put$4pcs$M8*16$screw s$and$flat$wash ers$and$tight e n$them.
!
!
!
!
!
!
!
To Next Page
Loading...
