STEP 3 (*Multi-Function Version Only)
1. Lock$ the$ 2pcs$ U-shape$ pipes$ to$ both$ upright$ tubes,$ fasten$ them $ with$ 4pcs$ M8*40$ screws$ and$ flat$
washers$and$nuts$and$tighten$them.$
2. Put$the$multi-function$frame$to$U-shape$pipes,$fasten$it$with$2pcs$M8*65$screws$and$flat$washers$and$
nuts$and$tighten$them.$
3. Disassemble$the$ 3pcs$M8*14$scr ews$under$massager$b y$multi$wrench,$and$put$massager$onto$the$top$of$
function$frame$and$tight en $the$scr e ws.$
$
STEP 4
1. Put$the$side$co vers$at$the$base$frame$as$shown$below.$
2. Put$the$safety$key$on$the$console$then$can$start$to$use$machine.$
To Next Page
Loading...
