EasyManua.ls Logo

Orbitalum ORBIWELD OW 65 - User Manual

Orbitalum ORBIWELD OW 65
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Machine no.:
Operating instructions
for responsible bodies and persons using the machine
Enclosed Orbital Welding Heads
ORBIWELD
OW 65, OW 115, OW 170
OW 38S, OW 76S, OW 115S
OW 12, OW 19
To work safely with this machine, please read through the operating instructions in full before initial operation.
Retain the operating instructions for future reference.

Table of Contents

Questions and Answers

  • M
    Michael Johnston MDAug 11, 2025
    What to do if the arc does not ignite in Orbitalum ORBIWELD OW 65 Welding Accessories?
    • E
      elizabethwilliamsAug 11, 2025
      If the arc doesn't ignite in your Orbitalum Welding Accessories, several factors could be at play. First, check for poor contact between the collets and tube; cleaning the surfaces or removing any insulating layers might help. Ensure you have a sufficient welding gas supply. The electrode gap may be too high and require adjustment, or the electrode tip could be worn, needing regrinding. Also, verify the contact between the electrode and rotor, cleaning if necessary. A broken cable would also prevent ignition, so consider replacing it. Lastly, high coolant conductivity can interfere; use only Orbitalum antifreeze and replace any nonfunctional coolant.
  • C
    Carlos CarterAug 17, 2025
    What to do if the arc ignites against parts of the Orbitalum ORBIWELD OW 65 welding head?
    • B
      bdillonAug 17, 2025
      If the arc ignites against parts of the welding head of your Orbitalum Welding Accessories, which can cause heavy damage, there are several things to check. The electrode may not be OK and needs replacing. The electrode gap might be too high and requires adjustment. The weld chamber could be dirty and needs cleaning. The pre-purge time might be too short and needs to be increased. Finally, ensure that the electrode is assembled correctly.
  • M
    Mr. Brandon Torres IIAug 23, 2025
    Why rotor turn does not start in Orbitalum ORBIWELD OW 65?
    • J
      Jon ScottAug 23, 2025
      If the rotor turn doesn't start in your Orbitalum Welding Accessories, check for particles inside the gear and remove them by cleaning. Also, verify the electrical connection of the plug. Finally, check the cable and power supply.
  • E
    Elizabeth ThomasAug 28, 2025
    How to fix Orbitalum ORBIWELD OW 65 Welding Accessories welding head not in fixed position?
    • C
      Catherine SwansonAug 28, 2025
      If the Orbitalum Welding Accessories welding head isn't in a fixed position on the tube after tightening, it could be due to the wrong tube tolerance; use adapted collets. Alternatively, the clamp latches may be wrongly adjusted; adjust the grub screw on the top clamp side.
  • L
    Laura BerrySep 3, 2025
    Why is the arc pulled aside with Orbitalum ORBIWELD OW 65 Welding Accessories?
    • R
      Randall OliverSep 4, 2025
      If the arc is pulled aside when using Orbitalum Welding Accessories, the electrode tip might be worn and need regrinding. Alternatively, the electrode might be ground incorrectly; use Orbitalum electrodes. Also, consider that the electrode quality might be bad.

Orbitalum ORBIWELD OW 65 Specifications

General IconGeneral
BrandOrbitalum
ModelORBIWELD OW 65
CategoryWelding Accessories
LanguageEnglish