Oregon Scientific EW102 - Getting Started; Main Unit Installation; Sensor Installation; Synchronising with Sensor

EN
3
3. °C / °F: select temperature unit
4. RESET: reset unit to default settings
5. SENSOR: initiate search for sensor
6. Pole compartment
7. Battery compartment
SENSOR
1
2
5
3
4
+-
1. LED indicator: ashes when remote unit transmits a
reading
2. Wall mount hole
3. RESET: reset unit to default settings
4. CHANNEL switch
5. Battery compartment
GETTING STARTED
MAIN UNIT INSTALLATION
Insert batteries:
1. Slide open the battery compartment cover.
2. Insert the batteries, matching the polarities.
3. Press RESET after each battery change.
4. Replace the battery compartment cover.
NOTE Batteries should not be exposed to excessive heat
such as sunshine or re.
SENSOR INSTALLATION
1. Slide open the battery compartment cover.
2. Insert the batteries matching the polarities (+/-).
SYNCHRONISING WITH SENSOR
1. Press CHANNEL on main unit to select a channel.
2. On sensor, slide channel switch to corresponding
channel. (For additional sensors, select a different
channel). Press RESET.
3. Press SENSOR on main unit to initiate search.