EN
11
To select to receive all warnings or only warnings
from specified localities:
1. Press COUNTY to enter the county-code display
from any clock display mode.
2. Press
or to switch between receiving all (ALL)
warnings or only warnings from specified local
areas [----].
If (1-6) [----] (specified local area) is selected,
local county codes need to be programmed into the
unit.
To enter the appropriate county code:
1. Press COUNTY to enter the county-code display
from clock-display mode.
2. Press COUNTY to bypass the county-code field 0
and advance to county code field 1.
3. To enter the county-code in this field, press and hold
COUNTY for 2 seconds. The extreme left county-
code digit will flash.
4. To enter the first county-code digit, press
or .
Remember: This part of the code subdivides a county
into localized sub-sections. If the county code has not
been subdivided into smaller sub-sections, select (0) in
the far left column.
5. Enter the remaining 5 digits by following the same
process. Press COUNTY followed by or .
A county can be subdivided as follows:
1 Northwest
2 North Central
3 Northeast
4West Central
5 Central
6 East Central
7 Southwest
8 South Central
9 Southeast
NOTE
To Next Page
Loading...
