Oregon Scientific WS903 - LCD Display; Operation and Setup; Getting Started

3
EN
SOR
POWER SUPPLY
GETTING STARTED
POWER: Turn on/off the unit.
SLEEP: View remaining time; enable sleep function
with diffusing / nature sound / light; set sleep timer.
TIMER: View auto timer ON status; enter timer
settings.
BRIGHTNESS / -: Toggle high/low LCD brightness;
decrease values of the setting.
DIFFUSE: Toggle through selection (ON / REPEAT
ON&OFF 30 seconds/ OFF).
LIGHT: Toggle through selection (Red / Orange /
Yellow / Green / Blue / Purple / Loop).
SOUND: Toggle through 5 soothing sounds.
VOLUME / +: Toggle through 3 sound volumes;
increase values of the setting.
CR2025 batteries - already installed
1.
2.
3.
4.
5.
6.
7.
8.
9.
LCD Display
Sleep mode is ON
Auto timer mode is ON
Soothing sound is ON
Lighting is ON
Diffusing is ON
Battery low / no battery
24HR clock format
AM/PM
Clock / settings
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove the battery insulator before use.
Pour maximum 300ml tap water in room tempera-
ture into the water tank.
Add few drops of essential oils into the water.
Put back the cover.
Plug in the power adaptor.
Press the infrared remote control on remote control
compartment to take it out.
After using the remote control, insert it to the
remote control compartment.
Press POWER to turn on the unit.
1.
2.
3.
4.
5.
6.
7.
8.
12 34 5
6
78
9
NOTE Do not use distilled water with this product.
Water temperature should be 15 - 40 ºC.
100% nature essential oil should be used.
Switch off the unit and unplug from the mains before
moving or cleaning the unit.