What to do if Oriental motor Remote Control shows overload?
If the Oriental motor Remote Control indicates an overload, it means a load exceeding the peak torque was applied longer than the 'overload alarm' parameter setting. To resolve this: * Reduce the load or extend the acceleration/deceleration time. * If in current control mode, increase the current limit value. * Verify the connection between the driver and electromagnetic brake.
Why does my Oriental motor Remote Control display overvoltage?
If your Oriental motor Remote Control is showing overvoltage, it could be due to a voltage exceeding the specified value being applied or a large inertial load being stopped abruptly (or vertical operation performed). You should: * Check the input voltage of the power supply. * If the alarm occurs during operation, reduce the load or increase the acceleration/deceleration time.
What to do if Oriental motor Remote Control shows excessive position deviation?
If your Oriental motor Remote Control displays 'Excessive position deviation,' it means that when the motor was in a current ON state, the difference between the command and actual positions exceeded the set parameter for overflow rotation alarm during current on, or the load is too large, or the acceleration/deceleration is too rapid. Try the following: * Reduce the load or make the acceleration/deceleration longer. * If the driver is in current control mode, increase the current limit value.
How to fix Oriental motor Remote Control main circuit overheat?
If the main circuit of your Oriental motor Remote Control is overheating, it indicates that the internal temperature of the driver has exceeded 85 °C (185 °F). Check and improve the ventilation condition in the enclosure.
What to do if Oriental motor Remote Control displays overspeed?
If your Oriental motor Remote Control is showing overspeed, the motor output shaft's rotation speed has exceeded approximately 4500 r/min. To correct this: * Check the 'electronic gear' setting and ensure the motor output shaft speed is set to 4500 r/min or less. * If the motor is overshooting during acceleration, increase the acceleration/deceleration time.
Why Oriental motor Remote Control shows undervoltage?
If your Oriental motor Remote Control is showing undervoltage, it means the main power was momentarily cut off or the voltage became too low. Check the input voltage of the main power supply.
What to do if Oriental motor Remote Control has communication switch setting error?
If you encounter a communication switch setting error on your Oriental motor Remote Control, it means the transmission rate setting switch (SW2) is out-of-specification. You should check the transmission rate setting switch (SW2).
Outlines critical instructions to prevent danger or injury during product use.
Details the procedures and methods for installing the motor and driver correctly.
Explains the different types of motor operations and their corresponding timing charts.
Details the various parameters used for configuring driver behavior and I/O functions.
Explains driver alarms and warnings, their causes, and recommended actions.
Provides guidance on diagnosing and resolving operational issues with the motor and driver.
General| Power Supply | DC |
|---|---|
| Voltage | 24 VDC |
| Communication | RS-485 |
| Protection Features | Overcurrent, Overvoltage, Overtemperature |
| Operating Temperature | 0°C to 40°C |
| Humidity | 85% or less (without condensation) |
To Next Page