Origin Effects BASSRIG - Page 2

fdfdf
1. GET CONNECTED
INSTR - Plug in your bass or other instrument.
AMP - Connect to amp or power amp.
DI OUT - Connect to your mixer or recording interface.
9VDC - Insert 9VDC 2.1mm centre-negative power supply
(minimum 150mA).
2. MATCH THE CONTROLS
Match the controls to the image here as a starting point for setting up your
tone.
3. SET THE AMP OUT EQ
HORN CUT - For cabs equipped with a tweeter, set the HORN CUT
switch to 2K or 4K to give a smooth overdrive tone and protect your
tweeter.
For cabs without tweeters, leave this switch in the o (centre) position.
Use the LF and HF trimmers to fi ne tune the pedal’s voicing to suit
your amp and cab.
LF - This control can reduce boominess in large cabs or fatten up
smaller cabs.
HF - This control can add some upper-mid presence or tame the top
end when using a hi-fi , modern amplifi er.
4. SHAPE YOUR VOICE
The pre-drive 3-band tone stack a ects the frequency response and
character of the overdrive.
TREBLE - Turn clockwise for a brighter tone and more aggressive
overdrive. Turn counterclockwise for a smoother sound.
MIDDLE - Turn clockwise for a warmer tone and rich overdrive.
Turn counterclockwise for a scooped tone and extra clarity.
BASS - Turn clockwise for a deep low end. Turn counterclockwise
for a thinner, more percussive sound. Tip: For very overdriven sounds,
lower BASS settings will improve tightness and defi nition.
BRIGHT/FAT - BRIGHT adds extra high frequencies in the preamp. Its
e ect is reduced as the DRIVE is increased. FAT reconfi gures the circuit
from Showman
®
to Bassman
®
spec. At cleaner settings, this can add
warmth and depth to the sound. As the DRIVE increases, FAT
mode will begin to sound out-of-control - in a good way!
BLK/TWD - The BLK setting is a Fender
®
“Black Panel” circuit with
a controlled, scooped tone. TWD selects a Fender
®
“Tweed” tone
stack and reduces negative feedback, adding more gain and mids.
5. DIAL IN YOUR OVERDRIVE
DRIVE - Turn up and go from clean to cranked, much like turning up a
classic non-master-volume amp.
6. BLEND IN YOUR DRIVE
BLEND - Turn counterclockwise to add in some of your bass guitar’s
clean signal. This can help preserve clarity when using overdriven
sounds.
FOR THE FULL OWNER’S MANUAL VISIT
WWW.ORIGINEFFECTS.COM
DI OUT
This balanced XLR output gives you an all-analogue simulation of a
roaring 2x15 bass cabinet, perfect for connecting direct to a PA or
recording interface.
DI CAB SIM switch - In the FX position, the cabinet simulator is
active only when the pedal is engaged. In the FX+BYP position, the
cabinet simulator is always active.
DI GROUND switch - Select GND if only using the DI OUT.
Select LIFT to eliminate ground loop hum when using both outputs.
FOR THE FULL OWNER’S MANUAL VISIT
The BASSRIG ‘64 Black Panel is an Analogue Amp Recreation, offering
all the sounds of the Fender
®
Showman
®
, Bassman
®
and 2x15 cabinet.