Function Setting
功能設定
5
3. 風速: 按風速(+) / (-)鍵，設定所需1至12段不同風速風速，LED顯示燈同時亮起。
按 鍵，風扇以超強風速運作約3分鐘，LED顯示燈同時亮起，之後會按
照之前設定的風速繼續運作。
3. S
PEED: Press the (+)/(-) key to adjust the fan speed to the desired level (1 to12 level).
The speed setting is displayed on the LED light. Press the key to adjust
the wind speed to “Gale” level within 3 minutes, then it will continue to
operate at the previously set wind speed.
4. 搖擺送風: 按下搖擺送風鍵 ，風扇以自動左右搖擺模式送風。
按下搖擺送風鍵 兩次，風扇以自動上下搖擺模式送風。
按下搖擺送風鍵 三次，風扇以自動上下左右搖擺模式送風。
如欲停止自動上下左右搖擺送風，再按此鍵一次。
4. OSC: Press the key to allow the Fan to LEFT/RIGHT oscillate the wind direction.
Press the key twice to allow the Fan to UP/DOWN oscillate the wind direction.
Press the key three times to allow the Fan to LEFT/RIGHT & UP/DOWN
oscillate the wind direction.
To stop the oscillation, press the key again.
立體搖擺對流掛牆扇
3D convection wall fan
5. 定時關機: 在風扇運行時，按下定時設置鍵 ，選定4個不同的自動關機時間，分別
由1、2、4、6小時，LED定時設置顯示燈將會亮起，並會顯示所選關機時間。
5. OFF TIMER: When the Fan is running, pressing the key to set desired auto power
off time, There are 4 time intervals, from 1,2,4,6-hour. The LED of timer
will be on and displayed the off time setting.
6. 預約開機: 在待機模式下，按下定時設置鍵 ，選定4個不同的預約開機時間，分別
由1、2、4、6小時，LED顯示
屏
將會顯示所選開機時間及閃動，當LED顯
示
屏
閃動時，可同時設置搖擺送風、人體感應、及風速等功能。
6. PRESET START TIME: In Standby mode, pressing the key to set desired preset
power start time, There are 4 time intervals, from 1,2,4,6-
hour. The LED will be flash on and displayed the start time
setting on the LED screen. OSC, ECO SENSOR and SPEED can
be set at the same time when the LED indicator flashes.
***注意：當完成功能設定後15秒，
LED顯示燈
會自動變喑。
Remarks: After settings, the
LED indicator
will change dumb automatically
after 15 seconds.
To Next Page
Loading...
Need help?
General
