User’ Guide
33
line Configure a terminal line
write Write configuratoin to nvram
reset Reboot Cable Modem
quit Disconnect
To list keywords or arguments, enter a question mark (?) in place of a keyword or argument. Include a
space before the ?. This form of help is called command syntax help, because it reminds you which
keywords or arguments are applicable based on the command, keywords, and arguments you already
have entered. This example shows what the show ? command displays on an Ambit Cable router:
CM>show ?
dhcp Display all options in DHCP response
version Display system version information
ip Display IP configuration
interface Display interface information
running-config Display Cable Router configuration
cpe-info Display CPE information
downstream Display current downstream information
upstream Display current upstream information
rip Display RIP information
nat Show NAT commands
user List login user(s)
access-list Display access list information
cpe-limit Display CPE limit information
snmp Display SNMP parameter
pppoe-forwarding Show PPPoE forwarding function status
To complete a partial command, keyword, or argument use the <Tab> key. This example shows what
how <Tab> key works:
CM>show inter<Tab>
CM>show interface
Redisplaying a command
To redisplay a command you previously entered, press the up-arrow key. You can continue to press the
up-arrow key for more commands.
To Next Page
Loading...
Need help?
General