User’ Guide
52
¾ interface ethernet mac-address {mac address}
Assign MAC address to ethernet interface.
Example:
CM>interface ethernet mac-address 0008.0E86.1118
CM>show interface ethernet
Interface Ethernet
MAC address: 0008.0E86.1118
IP address 192.168.100.1 subnet-mask 255.255.255.224
Link status: link
Mode: 100Mbps, full-duplex
¾ interface ethernet rip {enable|disable}
Enable/disable RIP on ethernet interface.
¾ interface ethernet rip send-version {1|2}
Set RIP version 1 or version 2 on ethernet interface.
¾ interface ethernet rip key-chain {1|2|none}
Set RIP key-chain to 1, 2, or none.
¾ interface ethernet rip auth-mode { none| md5| text}
Set RIP authentication mode to none, md5, or text.
¾ interface ethernet shutdown
Stop transmitting traffic on the ethernet interface.
¾ interface ethernet startup
Start transmitting traffic on the ethernet interface.
¾ interface cable upstream channel {id}
Change upstream channel ID.
¾ interface cable downstream preset {frequency}
Add frequency to downstream frequency preset table.
¾ interface cable rip {enable|disable}
Enable/disable RIP on cable interface.
To Next Page
Loading...
Need help?
General