EasyManua.ls Logo

Orion MIS-4230 - Troubleshooting and Plasma Panel Characteristics; Before Calling for Service

Orion MIS-4230
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
MIS-4220 / MIS-4220R / MIS-4230
53
Infinitely Expandable

Before calling for any repair, check the following and then refer to a near A/S center.

󱵛
If there is no problem with the screen or sound, the “tick” sound is likely to result y
from the cabinet lightly shrinking with the change of room temperature. The sound
does not affect product’s performance.
󱵛
As for a screen which is over 16:9 in width (such as cinema-sized one), no image y
may be displayed at upper and bottom part of the screen.
󱵛
Check whether the problem is caused by vehicle, streetcar, high-voltage cable or y
neon sign, which emitting interference wave or electromagnetic induction. Avoid any
interfering object.
󱵛
PDP sets or screen can be hot, because basic principle of PDP driving is Plasma y
discharge between electrodes.
It is not a defect or a malfunction of the product, you may continue to use the product. y

The followings are phenomena caused by characteristics of the plasma display panel.
Since it is not a fault, you may continue to use the product.
󱵛
Although the plasma display panel is manufactured with high-precision y
technology, there may exist black or twinkling spots on the screen.
Since it is not a fault, you may continue to use the product.
󱵛
Displaying static images such as still video frames or computer screen y
images for an extended period of time may cause burn-in effect.
The burn-in effect may be gradually reduced by displaying full white
pattern.
However, please always be careful in using static images on this product, y
because such burn-in effect may cause permanent damages in some
cases.
󱵛
When you turn on the product slight buzzing sound may be heard y
from the rear of display panel. Since it is not a fault, you may continue
to use the product.
󱵛
Optical film that is attached on the panel can be slightly decolorized y
after long time of use. The degree of decolorization may vary
depending on display contents and conditions.
It is due to the characteristics of the film, but it is not a defect.
(It is caused by chemical characteristics of the film.)




Downloaded From TV-Manual.com Manuals

Related product manuals