EasyManua.ls Logo

Orion UltraView - Binocular Specifications; 8 x42 Model Specifications; 10 x50 Model Specifications; Warranty Information

Orion UltraView
2 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To clean the binoculars, first puff air on the lens with a blower
bulb or with compressed air to remove the larger particles. Then
it’s a good idea to brush the lens with a soft lens brush. Next, put
two drops of lens cleaning fluid on a sheet of lens tissue (never
directly on the lens). Wipe the lens gently in a circular motion, tak-
ing care to avoid undue pressure or rubbing. Quickly remove the
excess fluid with a clean, dry lens tissue. On larger lenses, clean
only a small area at a time, using a fresh lens tissue on each area.
If dirt accumulates on an interior lens surface, do not attempt to
disassemble the housing and clean the lens yourself. Take the
binocular to a qualified optical repair technician.
Storage and Cold Weather
All optics, when exposed to excessive temperature changes or
high humidity, have the potential to fog up. In cold weather always
allow the optics to adjust slowly to the outdoor temperature for
a few hours prior to use by storing the binocular (in its case) in
a cool area such as an unheated garage or the trunk of a car.
Before bringing the binocular back inside a warm house after use,
store it in a cool area for one to two hours. It is important to then
open up the case, remove the binocular, take off the lens caps,
and let everything dry out overnight. Store the instrument in a
cool, dry place; storage in a humid environment will result in mold
growth and ruined optics. This is not covered by the warranty.
Repair
If your UltraView binocular should require internal cleaning, opti-
cal alignment, or other repairs, return it to Orion (if under war-
ranty) or take it to a qualified optical repair shop for service. Never
disassemble the binocular yourself. Doing so may disturb the pre-
cision optical alignment and will void your warranty.
Specifications
8x42
Magnification 8x
Objective lens aperture 42mm
Eye relief 22mm
Field of View 8.2° / 435 ft. @ 1000 yds.
Close focus 12 ft.
Prisms BAK-4, Porro
Antireflection coatings Fully multi-coated
Eyeguards Twist-lock, rubber covered
Tripod Adaptable Yes
Weight 27 oz.
10x50
Magnification 10x
Objective lens aperture 50mm
Eye relief 22mm
Field of View 6.5° / 345 ft. @ 1000 yds.
Close focus 16 ft.
Prisms BAK-4, Porro
Antireflection coatings Fully multi-coated
Eyeguards Twist-lock, rubber covered
Tripod Adaptable Yes
Weight 32 oz.
One-Year Limited Warranty
Orion UltraView Binoculars are warranted against defects in materials or workmanship for a period of one year
from the date of purchase. This warranty is for the benefit of the original retail purchaser only. During this war-
ranty period Orion Telescopes & Binoculars will repair or replace, at Orion’s option, any warranted instrument that
proves to be defective, provided it is returned postage paid to: Orion Warranty Repair, 89 Hangar Way, Watsonville,
CA 95076. If the product is not registered, proof of purchase (such as a copy of the original invoice) is required.
This warranty does not apply if, in Orion’s judgment, the instrument has been abused, mishandled, or modified,
nor does it apply to normal wear and tear. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state. For further warranty service information, contact: Customer Service
Department, Orion Telescopes & Binoculars, 89 Hangar Way, Watsonville, CA 95076; (800)-676-1343.
Orion Telescopes & Binoculars
OrionTelescopes.com
89 Hangar Way, Watsonville, CA 95076
Customer Support Help Line (800) 676-1343
© 2011 Orion Telescopes & Binoculars

Other manuals for Orion UltraView

Related product manuals