FEATURES
1 2
3
15
4
14
13
5
12
11
6
7
Figure
1
Figura
1
Abbildung
1
10 9
8
1
Polypropylene dust cap - moisture and UV resistant.
2
Oversized NBR (Nitrile-butadiene Rubber) surround for linear controlled
long excursion.
3
Paper cone - moisture and UV resistant.
4 Custom cast aluminum frame.
5
Vented Aluminum voice coil former (2.5" voice coil former).
6
8mm steel front plate.
7
Large 2 stack ceramic magnets.
8
8mm steel back plate/pole piece T yoke assembly.
9
1.125"
vent. Part of the enhanced voice coil cooling system (forced
convection).
10
PVC magnet protector.
11
High temperature Copper dual 2 ohm or dual 4 ohm voice coil.
12
Venting in voice coil former. Part of the enhanced voice coil cooling system
(forced convection).
1
3
Dual Interlaced Conex spider with stitched and looped tinsel leads
attached.
14
Custom terminal blocks.
15
ABS Trim Ring.
To Next Page
Loading...
