Need help?Do you have a question about the Orival OR-04-PE and is the answer not in the manual?
Describes the initial water flow and filtration stages through the coarse and fine screens.
Explains how the rinse cycle is initiated and the water flow during backwashing.
Details the mounting of rinse valves, hydraulic piston, and solenoid valve.
Provides guidance on filter installation and drain line connections for proper operation.
Addresses specific instructions for installing filters in an upside-down orientation.
Outlines the initial checks and procedures before the first operational use of the filter.
Describes the step-by-step process for starting up the filter system after installation.
Explains how to initiate a manual rinse using the OMNITROL 2000 control system.
Details the procedure for manual rinsing with the OMNITROL 500 control system.
Describes how to perform a manual rinse using the OMNITROL 100 control system.
Provides steps to diagnose why the filter is not initiating rinse cycles.
Guides on troubleshooting when rinse valves fail to close after opening.
Helps diagnose issues causing the filter to cycle repeatedly without completion.
Steps to follow when the filter's control system is not functioning.
Instructions for removing and reinstalling the coarse filter screen.
Details the process for removing and reinstalling the fine filter screen.
Explains converting the filter control system to use compressed air instead of water.
Describes the use and installation of a Controlled Outlet Valve for pressure management.
Details using an external water source with a COV for enhanced rinse performance.
Offers solutions to mitigate water hammer noise in filter installations.
Provides methods to adjust filter settings for optimal cleaning and rinsing.
General| Brand | Orival |
|---|---|
| Model | OR-04-PE |
| Category | Water Filtration Systems |
| Language | English |
To Next Page