20
-
--
Hazardous waste like oil, rubber and so one, must be stored in a environmentally safe way, or delivered at a
cered waste-disposal plant
-
This machine is designed to being towed by the drawbar only. Ensure the tractor is equipped with a drag bar
of sucient strength. -
Before set-up and mounng of the machine, aer being transported. The operator must carry out a visual
control of the machine, to reveal any transport damages.
Be aware of danger of overturning during transport. Don’t exceed recommended speed limits set by Orkel
Compacon Ltd. Maximum speed: 40km/t
-
-
All li done to the machine must be performed as
shown in picture 1 and 2.
Use a nylon strap to make a loop round the
front crossbeam (Beam Dim: 100 x 100mm)
Use liing points on the hydraulic jack stands
--
Secure the machine from moving if transported by lorry/train or boat. Only use
approved securing straps or chains, designed for the purpose.
There is four points of strapping, one on each hydraulic jack
stand. See picture to the right
Strapping point
Liing point, rear
Liing point, front
Picture 1 Picture 2
To Next Page
Loading...